Drive Train
Push-Pull Chain Adjusters
Easily adjusts chain by pushing or pulling rear axle for the best chain alignment possible. Fits 1950-65 cast iron Eagles only.
ACP-11$42.00 pair
Billet Adjusters
Billet aluminum. Set of two.
304105$41.95 pair
Magnetic Chain Alignment Tool
Makes chain alignment a much easier job.
APC-10$55.00
Chain O-Ring
200101-OR$95.00
Spare Master Links
876421-OR$6.00
Chain Lube
175 ml3605-0027$9.00
400 ml3605-0028$16.00
Aluminum Hubs
Rear 1958-65 cast iron Eagle.
876403-A$98.50
Rear 1960-65 Silver Eagle.
879638A$98.50
Front 1959-65 Eagle.
876407-A$77.95
Rear Sprockets
Aluminum.
65 ToothH-808239-A$84.95
60 ToothH-808238-A$79.95
53 ToothH-810794-A$74.95

Torque Converter Kits
This gives you a fully automatic infinite shift transmission. So if the motor begins to pull down the rear driven pulley will open up and down shift until you can maintain your RPM. With our jackshaft system, we bring power to the rear wheel on the same side that it originally was, without having to alter the sides. The gear range is 3-1 to 1.1. This gives you the full package to convert to an automatic transmission while maintaining your classic Cushman look.

1957 & Older Flat Head
This kit fits 1957 and older Cushman Eagles. Chain guard NOT included. The original works.

KIT CONTENTS:
  • 44 driver unit
  • 40 driven shiv
  • Belt
  • Jack shaft assembly
  • Sprocket
  • Belt cover
  • Belt cover brackets
  • NO chain guard included
PH-8$725.00

1958 & Newer
This fits Cushman Eagle Models from 1958 and up.

KIT CONTENTS:
  • 44 driver unit
  • 40 driven shiv
  • Belt
  • Jack shaft assembly
  • Sprocket
  • Belt cover
  • Belt cover brackets
  • Chain Guard
PH-9 $750.00

40 Series Clutch
For Vanguard engine conversion.
40 Series Clutch

Various size belts starting at $38.00
Comet Clutch Cover
For use with Comet 40 Series clutches. Includes mounting brackets.
CC-2$150.00
Comet Clutch (Driver)
For use with Comet 40 Series clutches. 44 mag. 1" bore.
209418A$219.00
7/8" Jackshaft (Driven)
Billet Aluminum. For 1958 - 1965 cast iron Eagles.
PolishedJSP78$450.00
Mill FinishJSM78$395.00

CVTECH CLUTCH
For Vanguard engine conversion.

CLUTCH KIT
10 1/8" - 10 1/4" belt centers :: 1 to 1.8 overdrive

KIT CONTAINS:
  • 1 3/16" belt
  • 1" driver
  • Driven
Cvtech Clutch Cover
Includes mounting brackets. For use with CVT-1 and CVT-2 clutches.
CC-1$160.00
Cvtech Rear Cover
Polished billet aluminum. For use with CVT-1 and CVT-2 clutches. See photo below.
CVT-3$105.00
7/8" Jackshaft (Driven)
Billet Aluminum. For 1958 - 1965 cast iron Eagles.
PolishedJSP78$450.00
Mill FinishJSM78$395.00

Rear cover CVT-3 shown above.